In the room tools, there are three structures: columns, beams, and flues. After adding columns and flues, the size and position can be adjusted, which is convenient for designers to restore the floor plan structure.
For Users
All users. If some enterprise accounts do not have the kitchen＆closet design entrance, please contact the CSC to apply.
Entrance
1. Enter the kitchen＆closet design and choose the room.
2. Select a structure, there are three structures: columns, beams, and flues.
Add Columns
1. Move the mouse to the lower right corner of the column, and the selection bar of square column and circle column will appear. You can choose by yourself.
2. After clicking the column, drag it into the floor plan and place it in the corresponding position.
3. You can directly drag and drop the adjustment points on the column to modify the size.
4. You can also modify the length and width of the column in the basic parameters in the right panel.
5. Adjust the column height, you need to switch to the custom in the parameter panel, and then modify the value.
Add Flues
1. After clicking the flues, drag it into the floor plan and place it in the corresponding position.
2. You can directly drag and drop the adjustment points on the flue to modify the size. You can also modify the length and width of the flue in the basic parameters in the right panel.
3. Adjust the flue height, you need to switch to the custom in the parameter panel, and then modify the value.
